Tin công tyTin khuyến mãiTin công nghệ
AccessoriesCases (Chasis)CPUFanHDD & HDD EnclosureHeatsink KeyboardMouseLCDMemory (RAM)MotherboardMini PCOptical DrivePSUSSDVideo Card (VGA)USB Flash DrivesPin & Camera AccessoriesThiết bị mạng
 

    Kingston HyperX FURY Black 4GB 2133MHz DDR4

    Hãng sản xuất:

    Kingston

    Mã sản phẩm:

    HX421C14FB/4

    Xuất xứ:

    Taiwan

    Bảo hành:

    36 tháng

    Kho hàng:

    Sẵn hàng

    Giá:

    700.000 VNĐ
      Thêm vào giỏ hàng

    Chi tiết sản phẩm

    Model

    Brand
    HyperX
    Series
    FURY
    Model
    HX421C14FB/4

    Details

    Capacity
    4GB
    Type
    288-Pin DDR4 SDRAM
    Speed
    DDR4 2133 (PC4 17000)
    Cas Latency
    14
    Timing
    14-14-14
    Voltage
    1.2V
    ECC
    No
    Buffered/Registered
    Unbuffered
    Color
    Black
    Heat Spreader
    Yes
    Features
    HyperX HX421C14FB/4 is a 512M x 64-bit (4GB) DDR4-2133 CL14 SDRAM (Synchronous DRAM) 1Rx8, memory module, based on eight 512M x 8-bit FBGA components per module. Each module kit supports Intel Extreme Memory Profiles (Intel XMP) 2.0. Each module has been tested to run at DDR4-2133 at a low latency timing of 14-14-14 at 1.2V. Additional timing parameters are shown in the Plug-N-Play (PnP) Timing Parameters section below. The JEDEC standard electrical and mechanical specifications are as follows:

    Note:
    The PnP feature offers a range of speed and timing options to support the widest variety of processors and chipsets. Your maximum speed will be determined by your BIOS.

    JEDEC/XMP TIMING PARAMETERS
    JEDEC/PnP: DDR4-2133 CL14-14-14 @1.2V
    XMP Profile #1: DDR4-2133 CL14-14-14 @1.2V

    FEATURES

    Power Supply: VDD = 1.2V Typical
    VDDQ = 1.2V Typical
    VPP - 2.5V Typical
    VDDSPD = 2.2V to 3.6V
    Nominal and dynamic on-die termination (ODT) for data, strobe, and mask signals
    Low-power auto self refresh (LPASR)
    Data bus inversion (DBI) for data bus
    On-die VREFDQ generation and calibration
    Single-rank
    On-board I2 serial presence-detect (SPD) EEPROM
    16 internal banks; 4 groups of 4 banks each
    Fixed burst chop (BC) of 4 and burst length (BL) of 8 via the mode register set (MRS)
    Selectable BC4 or BL8 on-the-fly (OTF)
    Fly-by topology
    Terminated control command and address bus
    Height 1.230" (31.25mm), w/o heatsink